Same size, 420 lb apart: on a single axle, two Carlisle Radial Trail HD tires in ST175/80R13 carry 2,720 lb in load range C, but 3,140 lb in load range D. To buy the right trailer tire, first read the trailer's certification label (or, failing that, the sidewall of your current tire), then choose an ST tire of the same size with an equal or higher load capacity. Here is how to decode every marking and avoid an ordering mistake before snowmobile season.

The short version

  • The tire size designation and the GAWR (gross axle weight rating) are shown on the trailer's label.
  • According to Transport Canada's TSD 120, the sum of the load ratings of the tires on an axle must not be less than the GAWR shown on the label.
  • According to Carlstar, the ST prefix identifies a tire intended for trailer use only.
  • The same size comes in several load ranges with different capacities: never order on size alone.
  • The number after the R (the last part of the size: 12, 13, 14 or 15) must match your rim diameter.

Where do I find my trailer's tire size?

Start with the certification label attached to the trailer. Transport Canada's TSD 120 ties each axle's GAWR to a tire size designation on that label: this is your original-equipment reference.

If the label is unreadable or missing, read the sidewall of the tire on the trailer. The size starts with ST and ends with the rim diameter, for example ST205/75R14. Also note the load range and the maximum load line, which we decode below.

Watch out for tires already replaced by a previous owner: they do not always match the original specification. When in doubt, trust the label rather than the tire.

What sizes are available in 12, 13, 14 and 15 inches?

The table below includes only sizes and data published by Carlstar (Carlisle Radial Trail HD) and Hankook (Vantra Trailer, the brand's first trailer tire). Capacities vary from one model to another, so always check the specification sheet for the exact tire.

DiameterST sizeData published by the manufacturer
12 in.ST145/R12Radial Trail HD: 1,220 lb at 65 psi (load range D) and 1,520 lb at 80 psi (load range E); 4-inch rim width; 21.4-inch mounted diameter; 75 mph
13 in.ST175/80R13Radial Trail HD: 1,360 lb at 50 psi (load range C) and 1,570 lb at 65 psi (load range D); 5-inch rim width; 24.1-inch mounted diameter; 81 mph. Also available as Vantra Trailer
13 in.ST185/80R13Radial Trail HD: 1,480 lb at 50 psi (load range C) and 1,710 lb at 65 psi (load range D). Also available as Vantra Trailer
14 in.ST205/75R14Radial Trail HD: 1,760 lb at 50 psi (load range C) and 2,040 lb at 65 psi (load range D); 5.5-inch rim width; 26.1-inch mounted diameter; 81 mph. Also available as Vantra Trailer
14 in.ST215/75R14Available as Hankook Vantra Trailer
15 in.ST205/75R15Available as Hankook Vantra Trailer
15 in.ST225/75R15Available as Hankook Vantra Trailer

As for typical use, Carlstar says the Radial Trail HD is often found on RVs and on utility, boat, horse and livestock trailers. Diameter alone does not tell you what the trailer is used for: the load you need to carry is what drives the choice.

For the ST215/75R14 and the 15-inch sizes, Hankook confirms the size is offered but not the capacity. Check the load and pressure on the model's listing in our trailer tires section.

How do I read an ST tire sidewall, step by step?

Let's take ST175/80R13 and ST205/75R14, two sizes offered by both Carlstar (Radial Trail HD) and Hankook (Vantra Trailer). Whatever the brand, the size reads in the same order.

  1. ST: Carlstar defines it as a Specialty Tire intended for trailer use only.
  2. 175 (or 205): the tire width.
  3. 80 (or 75): the aspect ratio, related to sidewall height. Some sizes, such as ST145/R12, do not show one.
  4. R: the construction, radial in this case. A different letter in this position indicates a different construction, such as bias ply.
  5. 13 (or 14): the rim diameter in inches. It must match your rim exactly.
  6. Service description: depending on the model, a load index and a speed symbol may follow the size. Their exact values appear on the manufacturer's specification sheet; Carlstar, for example, publishes 81 mph for the ST175/80R13 Radial Trail HD.
  7. Load range: a letter such as B, C, D or E. According to Carlstar, B is usually equivalent to 4 plies, C to 6, D to 8 and E to 10.
  8. Maximum load and pressure: a line reading something like "Max load… at… psi". For the Radial Trail HD in ST205/75R14, Carlstar's sheet lists 1,760 lb at 50 psi in load range C; the load range D version carries 2,040 lb at 65 psi.

A worked example: load range changes everything

Two ST175/80R13 Radial Trail HD tires on a single axle total 2,720 lb in load range C (2 × 1,360 lb) and 3,140 lb in load range D (2 × 1,570 lb). Under TSD 120, that total must not be less than the GAWR on the label. Simply asking for "a 13-inch trailer tire" is therefore not enough.

The logic is the same in 14 inches: two ST205/75R14 Radial Trail HD tires give 3,520 lb in load range C and 4,080 lb in load range D. Always compare that total with your axle's GAWR.

ST, LT or passenger tire: which one belongs on a trailer?

Tire typeWhat our sources sayOn your trailer
ST tireIntended for trailer use only, according to CarlstarThe intended choice when the label specifies an ST size
Other tires (LT, P-metric or metric)Not defined as trailer tires in our sourcesOnly if the trailer label and the manufacturer allow it

Why stick with ST? Because Carlstar reserves it for trailers and the label specifies a precise tire size designation. Replacing with the same ST designation is the simplest way to meet the TSD 120 requirement.

The reverse is also true: an ST tire does not belong on your car or pickup, since it is intended for trailer use only.

Which load range should I choose: C, D or E?

Start from the original load range printed on the tire and the GAWR on the label, then never go below that level. A higher load range increases the published capacity, but it comes with a higher maximum pressure: 50 psi in load range C and 65 psi in load range D for the ST175/80R13 Radial Trail HD.

Before moving up a load range, confirm with the wheel manufacturer that the rim is suited to that pressure. If your rims are rusty or questionable, our wheels section can help you start again on a sound base.

What should I check before buying trailer tires?

  • Trailer label: write down the GAWR of each axle and the tire size designation.
  • Exact size: ST prefix, width, aspect ratio, construction and diameter (ST185/80R13 is not ST175/80R13).
  • Load range: equal to or higher than the original.
  • Axle total: under TSD 120, the sum of the load ratings of the tires on the axle must be at least equal to the GAWR.
  • Rim: 12, 13, 14 or 15-inch diameter depending on the size; Carlstar's sheets also list a rim width (4, 5 or 5.5 inches depending on the size).
  • Matching on the same axle: we recommend the same size, construction and load range on both sides.
  • Published speed: check the figure on the chosen model's sheet.
  • Lead time: order before your first outing; delivery times are explained below.

Advice from our shop

Before ordering, take a photo of the trailer label and of the full sidewall of each tire, including the maximum load line. Those photos are often enough to avoid mixing up two similar sizes or two load ranges.

While you are at it, inspect the rims and the spare tire, which is easy to forget. On the same axle, we recommend replacing both tires together with the same size and load range, which also makes it easier to check the total required by TSD 120.

Ready to order your trailer tires?

Remember the order: label first, sidewall second, then an identical ST size with an equal or higher load range. You will find the available sizes in our trailer tires section or through our online shop; current prices are shown on each listing.

We deliver everywhere in Quebec, with no express service: usually 1 to 3 business days for tires in stock in Quebec and 5 to 8 for other products, with the expected date shown at checkout. Details are on our tire delivery page, and pickup at our Laval shop is also available.

Not sure about your sidewall code? Get in touch or call 450-256-1685, and browse our other tire guides to get ready for the season.

Ready to buy

Ready to order your tires?

Compare the tires available in your size, order online and choose delivery or installation at our Laval shop.

  • Free, fast delivery in Quebec when you buy 4 eligible tires or wheels
  • Installation by appointment on Saturdays, 9 a.m. to 4 p.m., until November 28

FAQ

Frequently asked questions

Can I put passenger car tires on my trailer?

Only if the trailer label and the manufacturer allow it; if the label specifies an ST size, stay with ST. Carlstar defines this type of tire as intended for trailer use only. When in doubt, check with the trailer manufacturer.

Can I install an ST tire on my car or pickup truck?

No. According to Carlstar, ST tires are intended for trailer use only. Your vehicle should be fitted with the tires specified by its manufacturer.

What does "Load Range C" or "Load Range D" mean on my trailer tire?

It is the tire's load range. According to Carlstar, load range C is usually equivalent to 6 plies and load range D to 8 plies. In the same size, the D version carries more: for the Carlisle Radial Trail HD in ST175/80R13, the sheet lists 1,360 lb at 50 psi in load range C and 1,570 lb at 65 psi in load range D.

Can an ST185/80R13 replace an ST175/80R13?

They are two different sizes with different published capacities. Since the trailer label ties the GAWR to a specific tire size designation, the simplest choice is to stay with the original size. If you want to change sizes, consult the trailer manufacturer first.

Should I replace both tires on the axle at the same time?

We recommend it, so both sides keep the same size, construction and load range. In every case, the combined load rating of the tires on the axle must remain at least equal to the GAWR, as required by Transport Canada's TSD 120.